Allied Telesis AT-S63 - Manual (Page 230)

Chapter 15: Event Log and Syslog Server Commands
230 Section II: Advanced Operations
ADD LOG OUTPUT
Syntax
add log output= output-id module=[all| module ]
severity=[all| severity ]
Parameters
output Specifies the output definition ID number.
module Specifies what AT-S63 events to filter. The available
options are:
all Sends events for all modules. This is the
default.
module Sends events for specific module(s). You
can select more than one module at a
time, for example, MAC,PACCESS. For a
list of modules, see Table 12, “AT-S63
Modules” on page 249.
severity Specifies the severity of events to be sent. The
options are:
all Sends events of all severity levels.
severity Sends events of a particular severity.
Choices are I for Informational, E for Error,
W for Warning, and D for Debug. You can
select more than one severity at a time (for
example, E,W). For a definition of the
severity levels, see Table 13, “Event Log
Severity Levels” on page 251. The default
is I, E, and W.
Description
This command configures an output definition.
Note
This version of the AT-S63 management software supports only
syslog servers as output definitions.
There are two steps to creating a output definition from the command line
interface. The first is to create the definition using “CREATE LOG
OUTPUT” on page 232. With that command you assign the definition an
ID number, the IP address of the syslog server, and other information.