Reset switch – Allied Telesis AT-S63 User Manual
Page 49
AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
49
RESET SWITCH
Syntax
reset switch
Parameters
None.
Description
This command does the following:
Performs a soft reset on all ports. The reset takes less than a second
to complete. The ports retain their current operating parameter
settings. To perform this function on a per-port basis, refer to “RESET
SWITCH PORT” on page 120.
Resets the statistics counters for all ports to zero. To perform this
function on a per-port basis, refer to “RESET SWITCH PORT
COUNTER” on page 140.
Deletes all dynamic MAC addresses from the MAC address table. To
perform this function on a per-port basis, refer to “RESET SWITCH
FDB” on page 150.
Example
This command resets the switch according to the description above:
reset switch