Allied Telesis AT-S63 - Manual (Page 594)

Chapter 32: Internet Protocol Version 4 Packet Routing
594 Section VII: Internet Protocol Routing
The interface must be configured for RIP version 2 in
order for you to specify a password. Passwords are
not supported in RIP version 1.
Passwords are sent in plaintext. The AT-S63
management software does not support encrypted
passwords.
Description
This command modifies the RIP settings of an interface. To initially add
RIP to an interface, refer to “ADD IP RIP” on page 575. To view the
interfaces on the switch, refer to “SHOW IP INTERFACE” on page 601.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command changes RIP on the VLAN4-3 interface to send version 2
packets, accept either version 1 or 2, and use the password “wa24pt” for
authentication:
set ip rip interface=vlan4-3 send=rip2 receive=both
authentication=pass password=wa24pt
This command changes RIP on the VLAN11-0 interface to accept both
RIP version 1 and version 2 packets:
set ip rip interface=vlan11-0 receive=both
This command changes RIP on the VLAN22-1 interface to send and
receive RIP version 1 packets. Since version 1 does not support password
authentication, the command disables it:
set ip rip interface=vlan22-1 send=rip1 receive=rip1
authentication=none
Note
Password authentication must be disabled to change an interface
from RIP version 2 to version 1.