Allied Telesis AT-S63 - Manual (Page 184)

Chapter 12: Port Mirroring Commands
184 Section I: Basic Operations
SET SWITCH MIRROR
Syntax
set switch mirror= port
Parameter
mirror Specifies the destination port for the port mirror. This is the port
where the traffic from the source ports will be copied. You can
specify only one port as the destination port. Specifying “0”
(zero) stops port mirroring so that the destination port can
again be used as a normal networking port.
Description
This command enables mirroring and specifies the destination port, or
stops port mirroring. To select the source ports, refer to “SET SWITCH
PORT MIRROR” on page 185.
Examples
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command stops port mirroring:
set switch mirror=0