Allied Telesis AT-S63 - Manual (Page 177)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 177
SET LACP SYSPRIORITY
Syntax
set lacp syspriority=0x priority
Parameters
syspriority Specifies the LACP system priority value for a switch.
This is a hexadecimal value from 0x1 to 0xffff. The
lower the number, the higher the priority. The default is
0x0080.
Description
This command sets the LACP priority of the switch. LACP uses the priority
to resolve conflicts between two switches to decide which switch makes
the decision about which ports to aggregate.
Example
The following command sets the LACP priority on the switch to 0x8000:
set lacp syspriority=0x8000