Allied Telesis AT-S63 - Manual (Page 643)

AT-S63 Management Software Command Line Interface User’s Guide
Section VIII: Port Security 643
SHOW RADIUSACCOUNTING
Syntax
show radiusaccounting
Parameters
None.
Description
This command displays the current parameter settings for RADIUS
accounting, which sends updates of supplicant activity on the switch’s
authenticator ports to the RADIUS server. Figure 59 is an example of the
information displayed by this command.
Figure 59. SHOW RADIUSACCOUNTING Command
The information displayed by this command is described here:
ˆ Radius Accounting Status - Specifies the status of RADIUS accounting
on the switch. A status of Enabled means that the switch is sending
supplicant updates to the RADIUS server: A status of Disabled means
that the feature is not activated. The default is disabled.
ˆ Radius Accounting Port - Specifies the UDP port for RADIUS
accounting. The default is port 1813.
ˆ Radius Accounting Type - Specifies the type of RADIUS accounting.
The only possible setting is Network.
ˆ Radius Accounting Trigger Type - Specifies the action that causes the
switch to send accounting information to the RADIUS server. An action
of Start_Stop sends accounting information whenever a client logs on
or logs off the network. This is the default. An action of Stop_Only
sends accounting information only when a client logs off.
ˆ Radius Accounting Update Status - Specifies whether the switch is to
send interim accounting updates to the RADIUS server. The default is
disabled.
Radius Accounting Configuration
-------------------------------------
Radius Accounting Status ...........: Enabled
Radius Accounting Port..............: 1813
Radius Accounting Type..............: Network
Radius Accounting Trigger Type......: Start_Stop
Radius Accounting Update Status.....: Disabled
Radius Accounting Update Interval...: 60