Allied Telesis AT-S63 - Manual (Page 588)

Chapter 32: Internet Protocol Version 4 Packet Routing
588 Section VII: Internet Protocol Routing
SET IP ARP
Syntax
set ip arp= ipaddress [interface= interface ] [port= port ]
[ethernet= macaddress ]
Parameters
arp Specifies the IP address of the static route entry to be
modified.
interface Specifies a new interface where the host is located.
An interface name consists of “VLAN” followed by the
ID (VID) or name of the VLAN where the interface is
to be assigned and an interface number, separated
by a dash (e.g., vlan4-0). The interface must already
exist on the switch. For background information, refer
to “Interface Names” on page 552.
port Specifies a new physical port on the switch where the
host is located.
ethernet Specifies a new MAC address of the host. The MAC
address can be entered in either of the following
formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
Description
This command modifies an existing static ARP entry in the ARP cache.
You can change all of the settings of an entry, except the IP address. To
change the IP address, you must delete the entry and add it again. To
view the ARP entries, refer to “SHOW IP ARP” on page 597.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command modifies the port number for the static ARP entry with the
IP address 149.42.67.8:
set ip arp=149.42.67.8 port=24
This command changes the MAC address for the static ARP entry with the
IP address 149.124.85.14:
set ip arp=149.124.85.14 ethernet=00:06:7a:22:11:24