Allied Telesis AT-S63 - Manual (Page 437)

437
Chapter 25
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 438
ˆ “DISABLE STP” on page 439
ˆ “ENABLE STP” on page 440
ˆ “PURGE STP” on page 441
ˆ “SET STP” on page 442
ˆ “SET STP PORT” on page 445
ˆ “SET SWITCH MULTICASTMODE” on page 447
ˆ “SHOW STP” on page 449
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on this feature, refer to Chapter 22,
“Spanning Tree and Rapid Spanning Tree Protocols” in the AT-S63
Management Software Menus Interface User’s Guide.