Allied Telesis AT-S63 - Manual (Page 262)

Chapter 16: Classifier Commands
262 Section II: Advanced Operations
DESTROY CLASSIFIER
Syntax
destroy classifier= idnumber
Parameters
classifier Specifies the ID number of the classifier to be deleted. The
number can be from 1 to 9999. You can delete more than
one classifier at a time. You can specify the classifiers
individually (e.g., 2,5,7) as a range (e.g., 11-14), or both
(e.g., 2,4-8,12).
Description
This command deletes a classifier from the switch. To delete a classifier,
you need to know its ID number. To display the ID numbers of the
classifiers, refer to “SHOW CLASSIFIER” on page 267.
You cannot delete a classifier if it is assigned to an ACL or QoS policy.
You must remove the classifier from the ACL or policy before you can
delete it.
Example
This command deletes classifiers 2 and 4:
destroy classifier=2,4