Allied Telesis AT-S63 - Manual (Page 410)

Chapter 24: SNMPv3 Commands
410 Section IV: SNMPv3
SET SNMPV3 ACCESS
Syntax
set snmpv3 access= access [securitymodel=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] readview=
readview writeview= writeview
notifyview= notifyview [storagetype=volatile|nonvolatile]
Parameters
access Specifies the name of the group, up to 32
alphanumeric characters.
securitymodel Specifies the security model. Options are:
v1 Associates the Security Name, or User
Name, with the SNMPv1 protocol.
v2c Associates the Security Name, or User
Name, with the SNMPv2c protocol.
v3 Associates the Security Name, or User
Name, with the SNMPv3 protocol.
securitylevel Specifies the security level. The options are:
noauthentication This option provides no
authentication protocol and no
privacy protocol.
authentication This option provides an
authentication protocol, but no
privacy protocol.
privacy This option provides an
authentication protocol and the
privacy protocol.
readview Specifies a Read View Name that allows the users
assigned to this Group Name to view the
information specified by the View Table entry.
writeview Specifies a Write View Name that allows the users
assigned to this Security Group to write, or modify,
the information in the specified View Table.
notifyview Specifies a Notify View Name that allows the users
assigned to this Group Name to send traps
permitted in the specified View.