Show igmpsnooping – Allied Telesis AT-S63 User Manual
Page 357
AT-S63 Management Software Command Line Interface User’s Guide
Section III: IGMP Snooping, MLD Snooping, and RRP Snooping
357
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None.
Description
This command displays the IGMP parameters. Figure 30 illustrates the
information that is displayed by this command.
Figure 30. SHOW IGMPSNOOPING Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 354.
Examples
The following command displays the current IGMP parameter settings:
show igmpsnooping
Equivalent Command
show ip igmp
For information, see “SHOW IP IGMP” on page 358.
IGMP Snooping Configuration:
IGMP Snooping Status ............... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect