History of new features, Version 2.1.0, Table 1. new features in at-s63 version 2.1.0 – Allied Telesis AT-S63 User Manual
Page 21
AT-S63 Management Software Command Line Interface User’s Guide
21
History of New Features
This section contains the history of the new features in the AT-S63
management software.
Version 2.1.0
Table 1 lists the new features in version 2.1.0 of the AT-S63 management
software.
Table 1. New Features in AT-S63 Version 2.1.0
Feature
Change
Chapter
Internet Protocol version
4 packet routing
Added the following new
features:
Chapter 32, “Internet Protocol
Version 4 Packet Routing” on
page 547
Equal Cost Multi-path (ECMP) to
support multiple routes in the
routing table to the same remote
destination.
“Equal-cost Multi-path (ECMP)
Routing” on page 556
“DISABLE IP ROUTE
MULTIPATH” on page 585
“ENABLE IP ROUTE MULTIPATH”
on page 586
Variable length subnet masks for
routing interfaces and for static
and dynamic routes.
-
DELETE IP ARP command can
now delete dynamic ARP entries
in addition to static entries.
DELETE IP ROUTE command
can now delete dynamic RIP
routes in addition to static routes.
SHOW IP ROUTE command has
the new parameter FDB to view
the status of the static and
dynamic routes.
A routing interface can be
identified by either the VID of the
VLAN (e.g., vlan1-0) or the
VLAN name (e.g., vlan-Sales-0).
Previously, a routing interface
had to be identified by the VID.