Allied Telesis AT-S63 - Manual (Page 366)

Chapter 22: MLD Snooping Commands
366 Section III: IGMP Snooping, MLD Snooping, and RRP Snooping
SHOW MLDSNOOPING
Syntax
show mldsnooping
Parameters
None.
Description
This command displays the following MLD parameters:
ˆ MLD snooping status
ˆ Multicast host topology
ˆ Host/router timeout interval
ˆ Maximum multicast groups
ˆ Host and router lists
To set the MLD parameters, refer to “SET IPV6 MLDSNOOPING” on
page 364.
This command displays the information in Figure 34.
Figure 34. SHOW MLDSNOOPING Command
The parameters in the MLD Snooping Configuration section are explained
“SET IPV6 MLDSNOOPING” on page 364.
MLD Snooping Configuration:
MLD Snooping Status ................ Enabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum MLD Multicast Groups ....... 64
Router Port(s) ..................... Auto Detect
Host List:
Number of MLD Multicast Groups: 1
VLAN Port/ Exp.
MulticastGroup ID TrunkID HostIP Time
-----------------------------------------------------------------------------------------
33:33:00:00:00:ab 1 6 fe80:0000:0000:0000:0208:74ff:feff:bf08 21
Router List:
VLAN Port/Trunk ID RouterIP
-----------------------------------------------------------------------------------------
1 14 fe80:0000:0000:0000:0200:cdff:fe12:bf08