Disable ip route multipath – Allied Telesis AT-S63 User Manual
Page 585
AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Internet Protocol Routing
585
DISABLE IP ROUTE MULTIPATH
Syntax
disable ip route multipath
Parameters
None.
Description
This command disables the ECMP feature. When the feature is disabled,
the routing table in the switch will route packets to a specific remote
destination using only one route even in cases where the table contains
multiple static or dynamic routes to the destination. Additional routes to the
same destination are placed in a standby mode. The default setting for
ECMP is enabled. For background information on this feature, refer to
“Equal-cost Multi-path (ECMP) Routing” on page 556. To view the current
status of ECMP on the switch, use the SHOW IP ROUTE command with
the GENERAL parameter. For instructions, refer to “SHOW IP ROUTE” on
page 607.
Example
The following example disables ECMP on the switch:
disable ip route multipath