Allied Telesis AT-S63 - Manual (Page 24)

Preface
24
Version 1.2.0 Table 4 lists the new features in version 1.2.0 of the AT-S63 management
software.
Table 4. New Features in AT-S63 Version 1.2.0
Feature Change Chapter
MAC Address Table Added new parameters to the CLI
commands for deleting and
displaying specific types of MAC
addresses in the MAC address
table. The new parameters are:
ˆ STATIC, STATICUNICAST,
and, STATICMULTICAST for
deleting and displaying static
unicast and multicast MAC
addresses.
ˆ DYNAMIC,
DYNAMICUNICAST, and,
DYNAMICMULTICAST for
deleting and displaying
dynamic unicast and multicast
MAC addresses.
Chapter 9, “MAC Address Table
Commands” on page 145
Modified commands:
“DELETE SWITCH FDB|FILTER”
on page 148
“SHOW SWITCH FDB” on
page 153
Quality of Service Added the following parameters to
the commands for creating and
modifying flow groups, traffic
classes, and policies:
ˆ TOS parameter for replacing
the Type of Service (ToS) field
of IPv4 packets.
ˆ MOVETOSTOPRIORITY
parameter for replacing the
value in the 802.1p priority
field with the value in the ToS
priority field in IPv4 packets.
ˆ MOVEPRIORITYTOTOS
parameter for replacing the
value in the ToS priority field
with the 802.1p priority field in
IPv4 packets.
ˆ SENDTOMIRROR parameter
for copying traffic to a
destination mirror port.
(Policies only.)
Chapter 19, “Quality of Service
(QoS) Commands” on page 291
Modified commands:
“CREATE QOS FLOWGROUP” on
page 295
“SET QOS FLOWGROUP” on
page 317
“CREATE QOS TRAFFICCLASS”
on page 305
“SET QOS TRAFFICCLASS” on
page 324
“CREATE QOS POLICY” on
page 298
“SET QOS POLICY” on page 320
MLD Snooping New feature. Chapter 22, “MLD Snooping
Commands” on page 361