Allied Telesis AT-S63 - Manual (Page 587)

AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Internet Protocol Routing 587
PURGE IP
Syntax
purge ip
Parameters
None.
Description
This command deletes all routing interfaces on the switch. Note the
following before performing this command:
ˆ All IPv4 packet routing on the switch ceases. The device, however,
continues to switch packets among the ports within the VLANs (but not
across the VLAN boundaries) using Layer 2.
ˆ All static routes are deleted from the route table.
ˆ The AT-S63 management software stops performing those
management functions that require access to a network management
device (e.g., a RADIUS server). For background information, refer to
“Routing Interfaces and Management Features” on page 560.
ˆ Deleting all interfaces deletes the local interface. This prohibits you
from remotely managing the device with a Telnet or SSH client, or with
a web browser. For background information, refer to “Local Interface”
on page 562.
ˆ Deleting all interfaces during a remote Telnet or SSH management
session immediately ends your session. To continue managing the
switch, you must start a local management session using the Terminal
Port on the unit.
ˆ Deleting all interfaces on the master switch of an enhanced stack
disables the device’s ability to function as the master switch of the
stack.
Example
This command deletes all routing interfaces on the switch:
purge ip interface