Avaya Cajun P882 - Manual (Page 223)

Cajun P550/P880/P882 Switch User Guide
Configuring DNS and RADIUS Clients
8-5
3. Refer to Table 8-1 to configure the RADIUS dialog box
configuration parameters;
Configuring a
RADIUS Client
Using the CLI To configure a RADIUS client using the CLI, enter the following
command from Configure mode:
> set radius authentication <parameters>
Refer to the Avaya P500/P880/P882 Switch Command Line Interface
Reference Guide for more details about this command.
Table 8-1. RADIUS Dialog Box Configuration Parameters
Parameter Definition
Enable State Enable or disable RADIUS on the switch.
Primary Server • IP Address - Enter the primary server IP address for
RADIUS.
• Shared Secret - Enter the primary server shared
RADIUS secret. This value is encrypted.
Secondary Server • IP Address - Enter the secondary server IP address
for RADIUS.
• Shared Secret - Enter the secondary server shared
RADIUS secret. This value is encrypted.
Source IP Address Enter the network access server IP address.
Realm Enter an ASCII name that will differentiate users. This
name will be appended to the user name.
Group Enter an ASCII name that will differentiate group users.
Retry Number Enter the number of times to re-send the Authentication
Request if there is no response.
Retry Time Enter the time (in seconds) to wait before re-sending an
Authentication Request.
UDP Port Enter the UDP port number. The default value is 1812.
Avaya-Service-Type
Required Enable or disable whether the service type to be granted to
a user is sent in an Access-Accept packet. This setting
ensures that the switch will not incorrectly allow access to
users that may already be set-up on the RADIUS server.