Avaya Cajun P882 - Manual (Page 377)

Cajun P550/P880/P882 Switch User Guide
Configuring IPX RIP Protocol
13-7
g. Enter 0 in the Ticks and Hops fields.
Filter 1 ensures that the advertising of network 10 on the interface
Backbone will not be suppressed. To suppress all other networks,
proceed with the creation of Filter 2.
To create Filter 2 from the web agent:
1. Repeat steps 1- 2 in the creating Filter #1 procedure.
2. Configure the following parameters:
a. Select Backbone from the Interface pull-down menu.
b. Enter 1 in the Precedence field.
c. Enter 0 in the Start Network field.
d. Enter ffffffff in the End Network field.
e. Select Outbound from the Direction pull-down menu.
f. Select Enable from the Filter/Suppress pull-down menu.
g. In the Ticks and Hops fields, enter 0, respectively.
3. Click CREATE to save your changes, or CANCEL to restore
previous settings.
Filter 2 ensures that the advertising of all networks on the interface
Backbone will be suppressed.
Together, Filter 1 and Filter 2 will act to suppress all network
advertising with the exception of network 10. It is important to note
that Filter 2 had the Precedence field set to 1 and Filter 1 had the
Precedence field set to 0. Any filter with a Precedence of 0 will
always override a filter with a precedence of 1 or higher.
Creating and
Modifying IPX
RIP Filters Using
the CLI To create and modify IPX RIP filters using the CLI, enter the
following command from Priv mode:
cajun# ipx rip-filter <precedence> <start-network>
<end-network> {outbound|inbound|both} {filter|
allow} [<filter-ticks> [<filter-hops>]]
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.