Avaya Cajun P882 - Manual (Page 331)

Cajun P550/P880/P882 Switch User Guide
Configuring the OSPF Routing Protocol
11-13
Modifying OSPF
Virtual Links
Using the CLI To modify an OSPF virtual link using the CLI, enter the following
command and make your desired changes from Configure mode:
cajun(configure router: ospf)# area <area-id>
virtual-link <router-id> [hello-interval
<seconds>] [retransmit-interval <seconds>] [dead-
interval <seconds>] [{authentication-key <key> |
message-digest-key <key-id> md5 <key>}]
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
Creating OSPF Summaries
The primary purpose of the OSPF summary is route aggregation.
Route aggregation is a group range of IP addresses that are linked to
a single address.
You can create a new OSPF summary from either the web agent or
the CLI.
Creating OSPF
Summaries
Using the Web
Agent To create a new OSPF summary using the web agent:
1. Select Summaries from the Routing > IP > OSPF group on the
web agent window,. The OSPF Summaries dialog box opens
(Figure 11-7).
Note: This dialog box will display OSPF summaries only if
you have previously configured one or more
summaries.
Figure 11-7. OSPF Summaries Dialog Box
2. Select CREATE. The Add OSPF Summary dialog box opens
(Figure 11-8).