Avaya Cajun P882 - Manual (Page 68)

2-2
Chapter 2
Cajun P550/P880/P882 Switch User Guide
Setting Up Your Laptop or PC Monitor
You need a laptop or PC to make a serial line connection to the
switch to complete initial switch setup. Table 2-1 lists the settings
required for the laptop or PC monitor to communicate with the
switch.
Configuring the Supervisor Module Using the CLI
To connect to the Web Agent, you must first use the serial command
line interface (CLI) to configure the switch’s IP address and a
subnetwork mask on the supervisor module.
To configure the supervisor module using the CLI:
1. Attach a 9-pin straight-through male-to-female serial cable
from the serial port on your laptop or PC to the serial port on
the supervisor module’s front panel (Figure 2-1).
Figure 2-1. Cajun P550 Switch Front View
Table 2-1. Laptop or PC Monitor Settings
Baud
Rate
Stop
Bits
Data
Bits
Flow
Control
Parity
9,600 1 8 Xon/Xoff None
Attach Ethernet
cable here (10Base-T
or 10/100Base-T)
Attach serial port
cable here
(console port)
Supervisor Module
front panel