Avaya Cajun P882 - Manual (Page 410)

15-18
Chapter 15
Cajun P550/P880/P882 Switch Configuration Guide
Adding or
Deleting
Interfaces to
NBP Filter Using
the CLI To add interfaces to an NBP filter using the CLI, enter the following
command from Configure mode:
> (config-if <interface-name>:)# appletalk
access-list <access-list-number>
<permit|deny> nbp <string>
To delete interfaces to an NBP filter using the CLI, enter the
following command from Configure mode:
> (config-if <interface-name>:)# no appletalk
access-list <access-list-number>
<permit|deny> nbp <string>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about these commands.
Creating an AppleTalk Zone Filter
You can create an AppleTalk Zone Filter using either the web agent
or the CLI.
Creating an
AppleTalk
Zone Filter
Using the
Web Agent
To create an AppleTalk zone filter using the web agent:
1. Select Zone Filter from the Routing > AppleTalk >
Configuration group on the web agent window. The
AppleTalk Zone Filter dialog box opens
(Figure 15-11).
Figure 15-11. AppleTalk Zone Filter Dialog Box
2. Select CREATE. The Add AppleTalk Zone Filter dialog
box opens (see Figure 15-12).