Avaya Cajun P882 - Manual (Page 72)

2-6
Chapter 2
Cajun P550/P880/P882 Switch User Guide
Connect one end of a crossover patch cable to the 10Base-T port
located on the layer 2 Supervisor module front panel, or the
10/100Base-T port on the layer 3 Supervisor module front panel
(Figure 2-1). Connect the other end to an out of band device.
Refer to Table 2-2 for an explanation of the pinouts for the
10Base-t crossover patch cable.
Open the web agent after you have completed the out-of-band
connection. Refer to the “Opening the Web Agent” section later in
this chapter.
Configuring the Switch Using the Web Agent
The switch provides an embedded HTTP server that allows you to set
all the switch’s parameters from the Web Agent. You can use this
interface for quick and simple configuration changes. Refer to
Chapter 18, “Analyzing Network Performance Using RMON and
Ethernet Statistics” for information on monitoring and configuring
the Cajun switch using the Cajun P550 Manager interface.
* Note: Although this chapter provides detailed procedures
explaining how to configure the switch using the Web
Agent, the corresponding CLI commands to do the same
task are listed after each procedure. Refer to the Cajun
P550/P880/P882 Command Line Interface Reference Guide for
detailed information about the applicable CLI
commands.
Table 2-2. Pinouts for 10Base-T Crossover Patch Cables
Pin # Color Pin # Color
1 WO 3 WG
2 O 6 G
3 WG 1 WO
4 B 4 B
5 WB 5 WB
6 G 2 O
7 WBr 7 WBr
8 Br 8 Br