ETC Cobalt Family v7.0.0 - Manual (Page 1017)

1015
Time Code Format
Time code must be entered in this format: hh.mm.ss.ff.
Time code is shown in the Playback view like this
Learn mode
Each time GO is pressed, the current time code timestamp will be recorded in the current sequence
step. See
System Settings - MIDI .
Trig in B or Auto Mode
Normally, only Sequence steps that are in the B field will be triggered by incoming MIDI Time Code.
Other Steps will not be trigged, even if the times match.
It is also possible to run the system so that any Sequence Step matching a specific Time Code time is
run automatically regardless if it is in the B field or not.If the "Auto- locate step" parameter is set to
"On", any step that is matching the incoming MIDI Time Code will be executed. See
System Settings
- MIDI .