ETC Cobalt Family v7.0.0 - Manual (Page 643)

641
If the In-time is changed to 10 seconds, the FCB-times will be 50% of 10 (= 5 seconds).
NOTE
In Congo plays files earlier than Version 4.2, the FCB Delay time was set to
100% due to the fact that Delay Times were inherited from the Delay In
time. These plays (pre-4.2) with FCB Delays set to 100% will be converted to
use a delay of 0s instead.
Default Attribute Time
The Default Attribute Time (3 seconds) is used mainly to keep noise and unnecessary mechanical
friction down when a Moving Device is positioned in the following situations:
• When attributes are executed from Independents
• When copying Blind attributes to Live
• When using Stop table for an old dynamic
• When you press Home Attributes
• When jumping in the sequence
• Using REFRESH in the Main Playback
To change this time see Attribute Settings .
NOTE
The Default Attribute Time does not affect how fast a palette is activated
from direct selects or directly. This time can be set on the fly - for example
#(s) DIRECT SELECT PALETTE.
See Shortcuts - Device Palette Activating