ETC Cobalt Family v7.0.0 - Manual (Page 671)

669
5. Press ESC to exit. Changes are stored automatically.
NOTE
(v5.0) If you change the scroller calibration for a device and close the Scroller
Calibration Editor, recorded data (presets, palettes) for the previous frame
values will be updated to the new frame values. Values between frames will
not be affected.
To "clear" calibrations from a device/scroller: Re-select the same scroller roll
in the Device list
Scroller Fan override
In the Attribute setup (SETUP & ATTRIBUTE) it is possible to specify an Override value for all
Scroller Fans. If you set a value > 0%, this value will be used instead of the Fan values programmed in
the Scroller Roll. This is useful for making a temporary and absolute override of all fans, for example
during long rehearsals when heat is higher than during a performance.