ETC Cobalt Family v7.0.0 - Manual (Page 417)

415
Chase - Introduction
A Sequence can be set to run in Chase mode. This means the Sequence will chase endlessly through
all Steps on the predefined times. There are several parameters that can affect how it will run in Chase
mode.
General Facts
• Chases are edited in the same way as Sequences.
• In addition to Sequences they have Rate and BPM.
• BPM can be set with TAP from the Master Playback.
• A Chase has playback modes such as Reverse, Bounce, Single Shot.
• You can link any chase to a sequence step using a Master Link.
• You can play back a chase from any playback, including the Main Playback.