ETC Cobalt Family v7.0.0 - Manual (Page 473)

471
Capturing levels or parameters
Regardless if Capture mode is active or not, it is always possible to capture channels or part of
channels. Capture mode is not toggled to a permanent active state by these commands (5.0).
OBSERVE
That all of these commands will affect the currently selected channels. If a number is entered first,
only this channel will be affected.
Action Key Feedback
Intensity and
parameters [CAPTURE] &
[CHANNEL] Captured channels will have a
red background for the channel
number.
Intensities [CAPTURE] &
[@LEVEL] Level is captured until released.
Parameters [CAPTURE] &
[ATTRIB] Parameters are captured until
released.
Single Parameters [CAPTURE] &
[Wheel_key] Parameters are captured until
released.
Focus parameters [CAPTURE] &
[FOCUS] Parameters are captured until
released.
Color parameters [CAPTURE] &
[COLOR] Parameters are captured until
released.
Beam parameters [CAPTURE] &
[BEAM] Parameters are captured until
released.
U1-U3 parameters [CAPTURE] & [U1-
U3] Parameters are captured until
released.
Recording only Captured channels
You can record only captured channels.
Action Key Feedback
Record captured [RECORD] & [CAPTURE] Levels and parameters of only
captured channels are recorded.