ETC Cobalt Family v7.0.0 - Manual (Page 977)

975
Remote Control - Introduction
There are a number of options for remote controlling a Cobalt system.
There are three main kinds of wireless remote controls.
RFR Phone Remote iRFR
The RFR Radio/USB
Remote is equipped with
a display and bi-
directional
communication.
A wireless phone can be
connected to the RJ11
connector in the back and
be used for basic remote
functions.
iRFR is a software for
iPhone and iPod that
provides bi-directional
communication over a
wireless LAN.
NOTE
To clear input from the Remote Fields go to the Clear Remote Fields node in
the Remote Controls Node.
See
Remote Controls .
Remote Control are enabled in the System Settings for remotes to work.
There is a specific setting to enable recording from the Remotes. Both are ON
by default.
See
System Settings - System .
Remote Controls and at mode
If your console is set to operate channels in at mode, the remote will also function in at mode. See
System Settings - General and Channels - Command Syntax .
HINTS
• 100%/0%/+%/-% will now complete pending at mode operations.
• C will abort pending two-digit level entries.
• Decimal point will complete pending at mode operations without pressing @.