ETC Cobalt Family v7.0.0 - Manual (Page 270)

268
*
Output Editor - Dimmer Check Mode
Dimmer Check mode is a fast way to check the outputs consecutively.
1. Select first output with # OUTPUT
2. Set a level for checking with # @ LEVEL (a level is given between 0-255. 128 = 50%)
3. Press + or - to use this level and step to the next/previous Output. Levels that are higher than zero
are restored automatically as they are passed by.
4. Deselect the last output to leave channel check mode (0 OUTPUT). Or, simply set that output to a
level of 0% (0 @ LEVEL or use the wheel)
Output Editor - Channel Check Mode
Channel Check mode is a fast way to check the channels consecutively in the output editor.
1. Select first output with # CH
2. Set a level for checking with # @ LEVEL (a level is given between 0-255. 128 = 50%)
3. Press + or - to use this level and step to the next/previous patched channel. Levels that are higher
than zero are restored automatically as they are passed by. Channels that are not patched will not be
lit.
4. Deselect the last channel to leave channel check mode (0 CHANNEL or C/ALT CH). Or, simply set
that channel to a level of 0% (0 @ LEVEL or use the wheel)