Using the status indicator, Using the wheel clamp – Dynojet 250iP: Pit Installation Guide User Manual
Page 100
Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 4
Basic CPI Operation
4-6
U
SING
THE
S
TATUS
I
NDICATOR
The status indicator provides information on the status of the CPI control and the
various inputs to the CPI.
• Status: Off—indicates the CPI may not be receiving power due to the dyno being
turned off or lack of power being applied to the dyno.
• Status: Steady On—indicates all inputs into the CPI are okay for normal dyno
operation and the CPI is receiving power.
• Status: Blinking—If the status indicator light is flashing with two short blinks on
and a long pause off, the Emergency Stop circuit is open. This can be caused by the
red button on the control panel being pressed or an external E-Stop (Emergency
Stop) condition is being fed to the CPI board. The E-Stop circuit must be closed to
allow for normal dyno operation.
• Status: Blinking—If the status indicator light is blinking with equal on and off time,
the interlock signal into the CPI board is open. This signal monitors the condition
of optional safety switches that will be attached to safety guards or the dyno room
door when guards are not used; this will allow dyno operation only when the
guards are in place or the door is closed. The E-Stop circuit takes precedence over
the interlock input.
U
SING
THE
W
HEEL
C
LAMP
This optional accessory requires the CPI and battery to operate. The wheel clamp
allows for quicker bike loading and unloading. The internal mechanism in the wheel
clamp closes on the bike's front wheel and tire to a calibrated amount of pressure
securing the bike. The indicator light between the wheel clamp buttons provides
status of the current state of the wheel clamp.
Pinch hazard. Keep hands, body parts, and other loose items clear. Failure to
follow these instructions can result in serious injury or equipment damage.
Risk of injury. Be sure the wheel clamp is free and clear of any obstruction. Do
not operate the dyno if the wheel clamp indicator light is not on steady.