Dynojet 250iP: Pit Installation Guide - Manual (Page 62)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Pit Covers
2-42
6 Place the right side drum cover over the drum module.
7 Loosely secure the right side drum cover using four 3/8-16 x 1/2-inch button-head
flange screws. Do not tighten.
8 Loosely secure the right side drum cover to the drum guard bracket using four
1/4-20 x 1/2-inch button-head flange screws.
9 Align the pit covers so the drum guard is centered on the drum both front to back
and side to side.
10 Tighten all pit cover screws.
Note: If this is a European dyno, you will need to adjust the EEC finger guards.
Refer to Appendix C for EEC finger guard installation instructions.
Figure 2-46: Right Side Drum Cover