Blower mounts, support arm and junction box – Dynojet 250iP: Pit Installation Guide User Manual
Page 36
Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Blower Mounts, Support Arm and Junction Box
2-16
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BLOWER MOUNTS, SUPPORT ARM AND JUNCTION BOX
Before routing the cables, you must decide which side of the dyno to mount the
monitor support arm. The choice is based on personal preference and easy access to
your computer. For the following instructions, we will show the support arm and
control panel mounted on the right side of the dyno.
M
ARK
AND
D
RILL
B
LOWER
M
OUNTS
AND
S
UPPORT
A
RM
M
OUNTING
H
OLES
1
Using the carriage mounting plate and the dyno frame as reference, position the
support arm and optional blower mounts as shown.
Note: The high pressure blowers are an optional accessory. If you did not order
high pressure blowers, you will not need to install the blower mounts.
2
Using the mounting plates as a template, mark and drill 1/2-inch holes.
3
Install the Red Head anchors according to the instructions in Appendix A.
Figure 2-18: Blower Mounts and Support Arm Placement
111.76 cm
(44.0 in)
24.13 cm
(9.5 in)
24.13 cm
(9.5 in)
‘mark and drill
(four places)
mark and drill
(four places)
111.76 cm
(44.0 in)