Routing the air brake cable and air hose, Routing the air brake cable and air hose -4 – Dynojet 250iP: Pit Installation Guide User Manual
Page 70
Advertising
Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 3
Air Brake
3-4
R
OUTING
THE
A
IR
B
RAKE
C
ABLE
AND
A
IR
H
OSE
1
Open the CPI front panel to access the breakers and Breakout board.
2
Route the air brake cable from the air brake solenoid to the CPI.
Note: The CPI end of the air brake cable splits in two.
3
Connect the cable with the two black wires to the Breakout board wiring block
labeled Brake.
4
Attach the 4-pin connector to port P7 on the CPI board.
Figure 3-2: Routing the Air Brake Cable
P7 on the
CPI board
brake wiring block
on breakout board
Advertising
This manual is related to the following products: