Dynojet 250iP: Pit Installation Guide - Manual (Page 44)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-24
5 Remove the control panel rear cover.
5a
Remove the two nuts from the top of the cover and set aside.
5b Remove the screw on the top of the cover and set aside.
5c Remove the screw on the side of the cover and set aside.
5d Remove the four screws on the back of the cover and set aside.
5e Remove the control panel rear cover and set aside.
Figure 2-25: Remove the Control Panel Rear Cover
CP010
top nuts
side screw
rear screws
top screw