Dynojet 250iP: Pit Installation Guide - Manual (Page 58)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Final Adjustments and Tests
2-38
P OWER C ARRIAGE F INAL A DJUSTMENTS AND T ESTS
The power carriage allows you to easily adjust for various wheel bases distances with
the press of a button. Refer to “Using the Power Carriage” on page 4-5 for more
information on using the power carriage. To route the power carriage cables refer to
“Routing the Power Carriage and Wheel Clamp Cables” on page 2-28.
Using the Control Panel, press the carriage forward and backward buttons and verify
that the motor does turn.
W HEEL C LAMP F INAL A DJUSTMENTS AND T ESTS
The wheel clamp is an optional accessory. To install the wheel clamp refer to “Wheel
Clamp” on page 3-26. To route the wheel clamp cables refer to “Routing the Power
Carriage and Wheel Clamp Cables” on page 2-28.
1
Place a stack of catalogs into the wheel clamp.
2 Using the Control Panel, press the close button and observe that the wheel clamp
does close. Hold the button until the motor turns off and the status light is on
steady.
3 Press and hold the right hand wheel clamp button then press the left hand button
to open the clamp.
Refer to “Using the Wheel Clamp” on page 4-6 for more information on using the
Control Panel.