Dynojet 250iP: Pit Installation Guide - Manual (Page 61)

I N S T A L L A T I O N
Pit Covers
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-41
Note: If this is a European dyno, you will need to install the EEC finger guards.
Refer to Appendix B for EEC finger guard installation instructions.
3 Loosely attach the drum guard bracket to the left side drum cover using four
1/4-20 x 1/2-inch button-head flange screws.
Note: Dynojet recommends using a T30 Torx driver (Snap-On PFTx30E) to
secure the 1/4-inch screws. For dynos with serial numbers lower than 2030152,
Dynojet recommends using a hardened 5/32-inch hex driver (such as
Snap-On Fa5E) to attach the 1/4-inch screws. A standard allen key may round off
in the shallow screw head.
Figure 2-44: Drum Guard Bracket
4 Place the left side drum cover over the drum module.
5 Loosely secure the left side drum cover using four 3/8-16 x 1/2-inch button-head
flange screws. Do not tighten.
Figure 2-45: Left Side Drum Cover
drum guard bracket