Dynojet 250iP: Pit Installation Guide - Manual (Page 35)

I N S T A L L A T I O N
Carriage Plate and Tire Carriage
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-15
I NSTALLING THE T IRE C ARRIAGE
1 Starting from the back of the dyno, slide the carriage under the carriage clamps.
2 Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block.
3 Secure the bearing bracket to the carriage using four 1/4-20 x 1/2-inch
button-head flange bolts removed earlier.
Figure 2-17: Install the Tire Carriage
TC053
nut block
carriage
clamp
carriage
screw
bearing bracket
carriage