Dynojet 250iP: Pit Installation Guide - Manual (Page 27)

I N S T A L L A T I O N
Eddy Current Brake
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-7
U NPACKING THE E DDY C URRENT B RAKE
1 Remove the four bolts securing the brake to the crate.
2 Remove the retarder connector plates, if present.
3 Determine if the brake is to be mounted on the left or right side of your dyno.
Make the following adjustments to the eddy current brake only if you want to
mount the brake on the opposite side of the dyno that it is currently set up for.
• Move the coupler and key to the other side of the brake.
To remove the key, use a punch and a hammer to apply pressure in the
direction of the arrows shown in Figure 2-7.
• The retarder connector plates (removed in step 2) will need to be moved to
the other side of the brake once the brake is installed in the pit.
• Move the temperature sensor to the other side of the brake.
Figure 2-6: Left or Right Side Brake Set Up
connector plate
eddy current brake set up for left side installation
eddy current brake set up for right side installation
coupler
temperature
sensor
connector plate
coupler
temperature sensor
connector plate
connector plate