Wheel clamp, Installing the wheel clamp, Installing the wheel clamp -26 – Dynojet 250iP: Pit Installation Guide User Manual
Page 92
Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 3
Wheel Clamp
3-26
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
WHEEL CLAMP
The wheel clamp allows you to easily adjust for various wheel thicknesses with the
press of a button.
Refer to “Using the Wheel Clamp” on page 4-6 for more information on using the
wheel clamp.
I
NSTALLING
THE
W
HEEL
C
LAMP
1
Remove the six 1/4-20 x 1-inch screws securing the wheel clamp cover. Remove
the cover and set the cover and screws aside.
Figure 3-25: Remove the Wheel Clamp Cover
2
Place the wheel clamp on the carriage. Align the four holes on the wheel clamp
with the holes on the carriage.
3
Secure the wheel clamp to the carriage using four 3/8-16 x 1/2-inch bolts.
Figure 3-26: Secure the Wheel Clamp to the Carriage
cover