Dynojet 250iP: Pit Installation Guide - Manual (Page 121)

R E D H E A D A N C H O R I N S T A L L A T I O N
Installation
Version 2 Model 200iP/250iP Motorcycl Pit Dynamometer Installation Guide
A-3
3 Using a hammer, drive the anchor flush with the surface of the concrete, or below
the surface if the hole depth exceeds minimum embedment.
Figure A-3: Red Head Anchor—Drive the Anchor Flush
4 Using a hammer, expand the anchor with the setting tool. The anchor is properly
expanded when the shoulder of the setting tool is flush with the top of the
anchor.
Note: Use only Ramset/Red Head setting tools to insure proper installation.
Figure A-4: Red Head Anchor—Expand the Anchor
setting tool