Dynojet 250iP: Pit Installation Guide - Manual (Page 45)

I N S T A L L A T I O N
Routing Cables
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-25
6 Route the control panel cable and RPM cable through the access hole on the side
of the control panel box and through the cable tie.
7 Attach the control panel cable to the Button board.
8 Secure the panel mount connector on the RPM cable to the control panel using
two #4-40 pan-head phillips screws.
Note: Routing the RPM cable is optional.
Figure 2-26: Attach the Control Panel Cable to the Button Board
9 Tighten the cable tie.
10 If you purchased the optional air brake, install the Emergency Stop Sticker at this
time. Refer to page 3-6 for directions.
11 Secure the rear cover to the control panel.
11a Replace the four screws on the back of the cover removed earlier.
11b Replace the screw on the top of the cover removed earlier.
11c Replace the screw on the side of the cover removed earlier.
11d Replace the two nuts removed from the top of the cover removed earlier.
Figure 2-27: Replace the Control Panel Rear Cover
control panel cable with
cable harness wrap
access hole
cable tie
button board
RPM cable
panel mount
connector
CP007A