Dynojet 250iP: Pit Installation Guide - Manual (Page 48)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-28
R OUTING THE P OWER C ARRIAGE AND W HEEL C LAMP C ABLES
The wheel clamp is an optional accessory. If you did not order this accessory, it is still
necessary to route the cables to the junction box. After you install the wheel clamp
you can finish routing the cables, refer to “Wheel Clamp” on page 3-26 for installation
instructions.
1
Route the power carriage cable (P/N 76950314) from the CPI through the
designated power pit conduit, through the pit, and out of the pit as shown in
Figure 2-33.
2 Route the wheel clamp cable (P/N 76950313) from the CPI through the same
conduit and along the same path as the power carriage cable.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 From the pit, route both cables through the junction box as shown in Figure 2-33.
4 Press each cable into the cable track.
Note: The cable must be pressed into the cable track before installing the cable
track ends and brackets.
5 Snap the cable track ends onto the cable track as shown below.
6 Secure the junction box cable track bracket to the cable track end using two 4-40
screws and nuts.
7 Secure the wheel clamp cable track bracket to the cable track end using two 4-40
screws and nuts.
Figure 2-30: A. Install the Cable Track Ends B. Install the Cable Track Brackets
PD050B
PD050A
junction box cable
track bracket
wheel clamp cable
track bracket cable track end
cable track end
A
B