Dynojet 250iP: Pit Installation Guide - Manual (Page 34)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Carriage Plate and Tire Carriage
2-14
2 Use the carriage plate to mark and drill mounting holes as shown in Figure 2-15.
2a
Using the carriage plate as a template, drill four 1/2-inch holes.
2b Install the Red Head anchors according to the instructions in Appendix A.
Figure 2-15: Carriage Plate Mounting Dimensions
3 Secure the carriage plate to the floor using four 3/8 x 1-inch bolts and
5/16-inch washers.
Figure 2-16: Install the Carriage Plate
66.04 cm
(26.0 in)
40.32 cm
(15.875 in)