Dynojet 250iP: Pit Installation Guide - Manual (Page 57)

I N S T A L L A T I O N
Final Adjustments and Tests
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-37
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FINAL ADJUSTMENTS AND TESTS
After you have installed all of your additional accessories and routed all necessary cables,
perform the following procedures to ensure the safe and effective operation of your dyno.
Note: Before you plug in your dyno, you or your electrician must refer to Appendix B
for detailed power information.
Always turn the power off when connecting and disconnecting cables.
T URNING O N THE D YNO P OWER
1 Replace the CPI cover if it was removed. Refer to page 2-22 for more information.
2 Plug the power plug into the power outlet.
3 Turn on the main breaker inside the CPI door.
Note: Use the main breaker to turn power on and off to the dyno.
Figure 2-39: Turn on the Dyno Power
PD025
main breaker
power plug