Dynojet 250iP: Pit Installation Guide - Manual (Page 133)

P O W E R R E Q U I R E M E N T S
Locations Using 50 Hz Power (Locations Other than North America and Japan)
Version 2 Model 200iP/250iP Motorcycl Pit Dynamometer Installation Guide
B-11
C ONNECTING THE D YNO
1 Turn off the main circuit breaker on the dyno. The main breaker is located inside
the CPI door. When the handle is in the down position all power into the dyno is
turned off. Refer to page 3-2 for breaker location.
2 Once you verify the voltages on the receptacle, connect the dyno to the
receptacle.
3 Check that the high pressure blowers are connected to the dyno. For more
information on installing and connecting the blowers, refer to page 3-25.
4 Turn on the main dyno breaker. Refer to page 3-2 for breaker location.
5 Turn on the dyno electronics and verify operation.
6 Test the CPI operations referring to “Basic CPI Operation” on page 4-2.