Dynojet 250iP: Pit Installation Guide - Manual (Page 24)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Installing the Dyno
2-4
R EMOVING THE D YNO FROM THE C RATE
You will need to provide equipment capable of lifting a minimum of 1,043 kg.
(2300 lb.) to lift the dyno (drum module) off the crate and into position in your dyno
room. You will also need a pair of straps capable of supporting 1,043 kg. (2300 lb.) to
attach to the dyno. Dynojet recommends using a single loop style strap.
# RECORD
Be sure you record the dynamometer number on the inside cover of this
manual.
1 Remove the four lag bolts and washers securing the drum module to the crate
base using a 9/16-inch socket, open or box end wrench.
2 Wrap the single loop straps around the drum module shaft.
3 Lift the drum module off the crate and move into position in your pit.
Figure 2-3: Remove the Dyno From the Crate Base
dyno number
stamped on frame
(not visible)