Dynojet 250iP: Pit Installation Guide - Manual (Page 7)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
v
W
ARNINGS
Disclaimers
Dynojet Research, Inc. (Dynojet) makes no representation or warranties with respect to the contents
hereof and specifically disclaims any implied warranties of merchantability for any particular purpose.
Dynojet reserves the right to revise this publication and to make changes from time to time in the
content hereof without obligation of Dynojet to notify any person of such revision or changes.
Dynojet is not responsible for false operation due to unexpected dynamometer operation such as may
be caused by static, software bugs, hardware failure, etc.
Dynojet is not responsible for damage resulting from improper installation of the dynamometer or
from improper service rendered to the dynamometer. Dynojet is not responsible for damage incurred
due to alteration of the dynamometer or components, use of unapproved parts, or abuse to the
dynamometer.
Do not connect or disconnect cables or components on the dynamometer with the power on.
Always wear protective clothing, ear protection, and eye protection (goggles, safety glasses) when
using and servicing the dynamometer.
Equipment Requires Proper Grounding
Various dynamometer components are equipped with a three-pronged plug (grounded) to guard
against shock hazards. The plug should be plugged directly into a properly grounded three-prong
receptacle. In locations where a two-prong wall receptacle is installed, it must be replaced with a
properly grounded three-prong dedicated outlet in accordance with the U.S. National Electric Code,
or equivalent, and local codes and ordinances. The work should be performed by a qualified
electrician.
Potentially Lethal Voltages
Components attached to and within the dynamometer operate with potentially lethal voltages. To
provide the greatest assurance of safety, the AC power cord(s) must be disconnected from the power
source before servicing electrical components or wiring. Disconnect all power cords before servicing
electrical components for the greatest assurance of safety.