Dynojet 250iP: Pit Installation Guide - Manual (Page 22)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Installing the Dyno
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNPACKING AND INSTALLING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipping company or
Dynojet before proceeding with unpacking.
Since this manual ships inside the packing crate, you must have already cut the bands
around the crate, removed the “remove by customer only” boards, and lifted the
pallet containing the pit covers from the top of the crate and set it aside in order to
remove the top of the crate.
It is important to follow the remaining steps carefully.
U NCRATE THE D YNO
1 Remove the crate braces, and sides.
Note: At this point you will want to inspect the exterior of the dyno for any
indications of damage. Report any damage immediately.
2 Remove the tire carriage and support arm and set aside. The tire carriage and
support arm are fastened to the bottom of the crate.
3 Remove any hardware boxes, the control panel interface, and accessories from
the crate and set aside.
Figure 2-1: Uncrate the Dyno
support arm
tire carriage