Dynojet 250iP: Pit Installation Guide - Manual (Page 123)

Model 200iP/250iP Motorcycl Pit Dynamometer Installation Guide
B-1
A
P P E N D I X
B
P
OWER
R
EQUIREMENTS
Different countries have different standards for delivery of AC (alternating current)
electricity to homes and buildings. The frequency (number of cycles per second) in
Hertz (Hz) varies from country to country.
North America typically uses 60 Hz power. Western Japan including the Osaka, Kyoto,
Nagoya, Hiroshima regions also uses 60Hz power. Eastern Japan including the Tokyo,
Kawasaki, Sapporo, Yokohoma, and Sendai regions uses 50Hz power.
Many other countries, such as Germany, the Netherlands, most European Union
countries have standardized on 50 Hz.
Note: If you are installing your dyno in an area such as North American or
Western Japan and will be using 60 Hz power, see “Locations using 60Hz Power
(North America & Japan)” on page B-2.
Note: If you are installing your dyno in the European Union or another country
where you will be using 50Hz power see “Locations Using 50 Hz Power
(Locations Other than North America and Japan)” on page B-7.
Note: See “Power Adjustment” on page D-2 for instructions to set up power
requirements for the theta controller.
To ensure safety and accuracy in the procedures, perform the procedures as they are
described.