Dynojet 250iP: Pit Installation Guide - Manual (Page 93)

A C C E S S O R I E S
Wheel Clamp
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
3-27
4 Bring the wheel clamp cable (three-pin connector) from the cable track over to
the wheel clamp. This cable was routed on page 2-28.
5 Install the wheel clamp cable strain relief to the side of the wheel clamp.
6 Plug the wheel clamp cable into the connector on the wheel clamp motor.
7 Replace the wheel clamp cover.
Figure 3-27: Secure the Strain Relief and Cable
W HEEL C LAMP F INAL A DJUSTMENTS AND T ESTS
1 Place a stack of catalogs into the wheel clamp.
2 Using the Control Panel, press the close button and observe that the wheel clamp
does close. Hold the button until the motor turns off and the status light is on
steady.
3 Press and hold the right hand wheel clamp button then press the left hand button
to open the clamp.
Refer to “Using the Wheel Clamp” on page 6-6 for more information on using the
Control Panel.
wheel clamp cable
strain relief
cable track
wheel clamp
motor connector